Suggestions for loading mods??

Suggestions for loading mods??

Joined: June 9th, 2007, 7:33 pm

December 30th, 2008, 7:07 am #1

I like the Disco, hate the tiny loading area. Its made for tiny fingers. Anyone have mods for improving the breech or loading gate? thanks!
Reply
Share

Joined: May 25th, 2008, 4:38 am

December 30th, 2008, 2:33 pm #2

..like this mag for the QB78....have not seen an update for awhile...

http://www.qbmags.com/

Reply
Share

Joined: September 21st, 2007, 12:13 pm

December 30th, 2008, 10:56 pm #3

I like the Disco, hate the tiny loading area. Its made for tiny fingers. Anyone have mods for improving the breech or loading gate? thanks!
the space from the front of the bolt probe to the load port of the barrel will help you, you can do this by cutting a notch in the back end of the bolt where it contacts the cocking pin in the hammer. The notch has to be a few thousandths short of the current space from the bolt handle to the back end of the slot for it in the breech, if not the hammer will not latch behind the sear when the gun is cocked.
Reply
Share

Joined: May 24th, 2008, 3:14 am

December 31st, 2008, 5:24 am #4

and have no problems loading my 22cal without even looking and I have mine scoped with a centerpoint 4-16x40
Reply
Share

Joined: March 19th, 2006, 4:15 am

January 1st, 2009, 1:53 am #5

put in on the side ledge point forward and roll it in the port with a side and forward motion. works on the 177 and the 22 which is a little easier to do it with. i got one of these center point 4x16 scopes too, like it, as it moves the point of impact when i turn the knob. john
Reply
Share

Joined: June 9th, 2007, 7:33 pm

January 1st, 2009, 6:21 pm #6

I took my 22 out yesterday and learned that if I use my off-finger to wall up the opposite side of the port it keeps the pellet pointing correctly. Speeded up the loading quite well.
Reply
Share

Joined: March 19th, 2006, 4:15 am

January 1st, 2009, 11:36 pm #7

of a brass cleaning rod that i used on the 177 if a pellet went in wrong and wouldn't come out by bumping to stock with the heel of my hand. i insert it in the muzzle and elevate the muzzel untill it slides down the barrel and dislodges the pellet. some of the 177's would trip on the screw recess in the bottom of the breech. so far, havn't had that problem with the 22. john
Reply
Share