regulator question

regulator question

Joined: August 16th, 2006, 10:39 pm

December 11th, 2010, 9:29 pm #1

If I was doing a QB78 PCP tube rifle....

Could I buy a paintball reg and take all the insides out and turn up a housing for them with two orings on the OD and a gauge port like the Discovery one???

Anybody know the OD of the insides of a common brand paintball regulator?

Reply
Share

Joined: March 28th, 2002, 6:54 pm

December 11th, 2010, 11:09 pm #2

a better solution in the long run.
Reply
Share

Joined: August 16th, 2006, 10:39 pm

December 11th, 2010, 11:18 pm #3

I will be looking for alot of QB input and Ideas over the holiday break
Reply
Share

Joined: August 16th, 2006, 10:39 pm

December 11th, 2010, 11:22 pm #4

a better solution in the long run.
I could just turn down the outside and cut two oring grooves on the OD
Reply
Share

Joined: December 17th, 2008, 7:33 pm

December 12th, 2010, 10:26 pm #5

Have a look here for some ideas for stuff to do on your lathe

http://ukchineseairgunforum.myfreeforum ... sc-430.php

you'll need to register.

Cheers
Simon
Reply
Share

Joined: August 16th, 2006, 10:39 pm

December 12th, 2010, 10:32 pm #6

nt
Reply
Share

Joined: May 28th, 2007, 10:10 pm

December 13th, 2010, 7:37 am #7

If I was doing a QB78 PCP tube rifle....

Could I buy a paintball reg and take all the insides out and turn up a housing for them with two orings on the OD and a gauge port like the Discovery one???

Anybody know the OD of the insides of a common brand paintball regulator?
http://www.network54.com/Forum/113813/t ... ers+-+long
Reply
Share