Newby CFX Question

Newby CFX Question

Joined: September 25th, 2005, 10:46 pm

March 11th, 2007, 8:40 pm #1

I have had the CFX for a few wks now and am just getting around to scoping the gun...I have some Beeman 5030 mounts that I would like to use. The CFX however has a mounting rail that is attached to the dove tails that are cut into the gun. The Beeman mounts will not tighten on the rail mounted on the gun. I "assume" it is ok to remove the rail that is attached to the dove tails?? What is the purpose of the sloted screw that goes down into the rear of the rail mounted on the gun. So if it is ok to remove the attached rail will the Beeman mounts fit the dove tails cut into the gun...TIA
Reply
Share

Joined: February 11th, 2007, 10:27 pm

March 12th, 2007, 7:00 pm #2

<P>Allen, </P>
<P>The 5030's should bolt right up to the rail on the CFX.. mine did. Try rotating the little clamp</P>
<P>part on the bolt side 180 degrees, they are designed to fit 11mm on one of the ends and 3/8ths</P>
<P>on the other.</P>
<P>Roald.</P>
Reply
Share