New Disco problems

New Disco problems

Joined: August 14th, 2011, 12:11 pm

August 23rd, 2011, 12:52 pm #1

Got a new discovery .22 last week.I filled it to 2000 psi from my scuba tank and tried and fired three shots off the back deck. Put the rifle away, and when I looked at the gauge the next day, it appeared as though all the remaining air had leaked out. I had ordered a power adjuster and HDD from AoA, and when they arrived the next day, I installed them. The parts diagram that came w/ the parts wasn't that great, bur I had good diagrams from the Crosman website that I had printed out. All went well w/ the install,except the transfer port and seal fell out when I removed the Breech/barrel from the air tube. I thought I replaced them correctly, tapered end down and the stepped end up. The next day, I mounted a scope,filled to 2000 psi. and tried a few shots at my bullet trap. The shot were so weak the pellet barely made it to the trap. I had had the power adjuster screwed maybe half way out, so I turned it out a few more turns, same thing, very weak. I thought I must have reassembled it wrong but couldn't see how. Checked the rifle again the next day and all the air had leaked out again. ?????? Any suggestions?
Reply
Share

Joined: February 16th, 2009, 7:41 pm

September 19th, 2011, 3:03 pm #2

from whom u purchase it cause if u keep spending it will be like buying two...
Reply
Share

Joined: October 4th, 2010, 1:01 pm

October 10th, 2011, 2:31 am #3

He has modded it and disassmebled it and there fore voided ANY warranty.

Manufacturers shouldn't be expected to warranty "wanna be air gun modders" mutilation of their guns.

IF he had sent it back BEFORE he hacked it I would say yes they need to fix it. But not now!!

Too bad! You messed with it, it don't work, and it SHOULD be your problem!!!
Reply
Share