Pull back the bolt and the hammer will not catch on the trigger assembly. Well I shouldn't say it doesn't catch, it catches but then releases right away without touching the trigger.It's almost like the seer is rounded. Anyone have any ideas before I tear into it?
Joe

if not that is it!

Pull back the bolt and the hammer will not catch on the trigger assembly. Well I shouldn't say it doesn't catch, it catches but then releases right away without touching the trigger.It's almost like the seer is rounded. Anyone have any ideas before I tear into it?
Joe

changed hammer springs.You may have spring bind.
Power adjuster >turn in a couple of turns
Different spring> go back to the old one or shorten the new one so it does not bind.
Thats the only thing I can think of Joe that may be screwing up your Disco.
Of course who the heck am I ?? Just your old pal


BBGun Bob

Air Guns Create Questions????
Together we can write the answers!!

if not that is it!

Had the same problem before and found out that its the trigger safety.It should be in all the time coz the spring in the trigger assembly is resting on it.

if not that is it!

I took it out the other day so I could clean the stock and never put it back. Thanks so much.
Joe

changed hammer springs.You may have spring bind.
Power adjuster >turn in a couple of turns
Different spring> go back to the old one or shorten the new one so it does not bind.
Thats the only thing I can think of Joe that may be screwing up your Disco.
Of course who the heck am I ?? Just your old pal


BBGun Bob

Air Guns Create Questions????
Together we can write the answers!!

Or old pal because you're up in years like I am, LOL.
Joe

Air Guns Create Questions????
Together we can write the answers!!