M-Rod Hammer Spring Preload Setting Drifts

M-Rod Hammer Spring Preload Setting Drifts

Joined: November 4th, 2010, 7:35 pm

December 11th, 2010, 9:57 pm #1

Jeff did a great step by step on ceasing the hammer stroke f/ drifting.

http://www.network54.com/Forum/79537/me ... +difficult...

Any ideas on stopping the hammer spring preload f/ moving?
Last edited by Lammy1000 on December 11th, 2010, 9:58 pm, edited 1 time in total.
Reply
Share

Joined: March 28th, 2002, 6:54 pm

December 11th, 2010, 10:37 pm #2

but not likely to drift.
Reply
Share

Joined: November 4th, 2010, 7:35 pm

December 11th, 2010, 10:56 pm #3

I just tightened the set screw to hold the hammer stroke in position, but I was hesitant to fully unscrew the hammer preload screw for removal and loc-tite/nail polish application.

Can the hammer preload screw be entirely removed to apply thread locker?
Reply
Share

Joined: August 16th, 2006, 10:39 pm

December 11th, 2010, 11:06 pm #4

Jeff did a great step by step on ceasing the hammer stroke f/ drifting.

http://www.network54.com/Forum/79537/me ... +difficult...

Any ideas on stopping the hammer spring preload f/ moving?
nt
Reply
Share

Joined: November 4th, 2010, 7:35 pm

December 12th, 2010, 12:03 am #5

Hey Tom, I was inside this gun and tightened #42 to stop the hammer stroke from moving. The issue we're trying to now solve is to how to stop the hammer spring preload screw from moving. Thanks for trying.
Reply
Share

Joined: August 16th, 2006, 10:39 pm

December 12th, 2010, 6:07 pm #6

nt
Reply
Share

Joined: November 4th, 2010, 7:35 pm

December 12th, 2010, 7:00 pm #7

I did not tighten screw #42 enough the first time allowing the hammer stroke to bach out full ccw. I then tightened #42 a bit more and added a small amount of blue loc-tite to the threads. That small screw might strip if I need to adjust in futue, so Iwill apply heat w/ the tip of a soldering gun.

To stop hammer preload from moving I used a screw to seat against the adjuster.
Reply
Share