m-rod barrel band delete spacer

m-rod barrel band delete spacer

Joined: July 1st, 2009, 10:47 pm

January 14th, 2011, 5:00 am #1

i have seen pics of these spacers that allow you to remove the barrel band. did some searching but nothing came up. where can i find these?

thanks
Reply
Share

Joined: July 12th, 2006, 11:35 pm

January 14th, 2011, 1:20 pm #2

know this too.
Good post.
Reply
Share

Joined: March 21st, 2010, 3:13 pm

January 14th, 2011, 2:16 pm #3

i have seen pics of these spacers that allow you to remove the barrel band. did some searching but nothing came up. where can i find these?

thanks
g. davis has them . but it makes the bbl. flex. n/t
Reply
Share

Joined: March 28th, 2010, 10:18 pm

January 15th, 2011, 1:05 pm #4

i have seen pics of these spacers that allow you to remove the barrel band. did some searching but nothing came up. where can i find these?

thanks
Check my web page.

My self and some others, believe the M-rod shoots better without the band.

The set screws from the BBand leave indentions in the fill adapter assy.
If you remove it to install a depinger, it may not be aligned like it was at first.
But the set screws want to use the same indentions. This makes it hard to reposition the BBand in small amounts.
Somtimes they get bumped in shipping, the resulting indentions and marks from the set screws again, make it difficult to position the BBand.

I think the intent is for the shroud to be freefloated.
But the BBand can interfere with this intent.

Rickster

www.rickd.net
Last edited by RicksterShooter on January 15th, 2011, 1:55 pm, edited 1 time in total.
Reply
Share

Joined: March 28th, 2010, 10:18 pm

January 15th, 2011, 4:27 pm #5

Check my web page.

My self and some others, believe the M-rod shoots better without the band.

The set screws from the BBand leave indentions in the fill adapter assy.
If you remove it to install a depinger, it may not be aligned like it was at first.
But the set screws want to use the same indentions. This makes it hard to reposition the BBand in small amounts.
Somtimes they get bumped in shipping, the resulting indentions and marks from the set screws again, make it difficult to position the BBand.

I think the intent is for the shroud to be freefloated.
But the BBand can interfere with this intent.

Rickster

www.rickd.net

www.rickd.net
Reply
Share