"Lawyer Spring" in the Gen 2 Marauder trigger assembly

"Lawyer Spring" in the Gen 2 Marauder trigger assembly

Joined: July 12th, 2016, 11:40 pm

May 18th, 2017, 1:29 am #1

What's the story with this, which one is it ? Any input or suggestions? Thanks in advance. Mike.
Reply
Share

Joined: May 6th, 2013, 6:24 pm

May 18th, 2017, 1:50 am #2

Reply
Share

Joined: July 12th, 2016, 11:40 pm

May 18th, 2017, 12:56 pm #3

Thank You,Bill.Just what I wanted to know! nt
Reply
Share

Joined: December 23rd, 2007, 1:28 am

May 18th, 2017, 8:38 pm #4

What's the story with this, which one is it ? Any input or suggestions? Thanks in advance. Mike.
from someone who's done it...I'll never go back to stock!!!
My trigger is as light as a feather.
Best trigger out of all my 20 something airguns/pistols.
You wont believe the difference it makes, just removing that spring.
Reply
Share

Joined: July 11th, 2001, 6:08 pm

May 20th, 2017, 1:02 pm #5

like in the video?
Reply
Share

Joined: May 6th, 2013, 6:24 pm

May 20th, 2017, 1:30 pm #6

You CAN remove it but you need to put an o-ring on the pivot-point to act as a spacer before you put sideplate back on.
Reply
Share

Joined: July 12th, 2016, 11:40 pm

May 20th, 2017, 7:05 pm #7

Put the stock adjustment spring back in. ( I previously replaced it with a lighter spring but after removing the lawyer spring,it was Way too light.) Polished up the sear,ect. with up to 1500 wet/dry. I used a couple very small,thin washers to take up the space left by the big honkin lawyer spring. Lubed the pivots with some leftover Vortek lube and a Light application of moly on the sear contact areas.I made some subtle adjustments​ to the 1st and 2nd stage screws,a bit to the weight adjustment screw and WHA-LAAA! (VIOLA?) The trigger is now the equivalent to Any of my others..or better! With the exception of my Diana 75. Thanks for the help guys, just Awesome!! ...Mike
Reply
Share