Is it easy to replace mrod breach seal? Nt
5 posts
• Page 1 of 1
-
- Joined: June 22nd, 2012, 7:35 pm
best luck by taking the barrel off. I also used a wood dowel from the opposite side to keep the oring from going too far. Maybe a long cleaning rod would also work, just something to keep the o-ring from going too far into the barrel or to push it back out when it does go too far.
Hope this helps.
Hope this helps.
-
- Joined: January 28th, 2016, 5:25 pm
shooting the rifle a couple of times with the bolt open(no pellet).Otherwise,use a pick and pull it out.Be wicked carful not to scratch the groove that holds it,if your pick is steel.
Silicon lube a new o-ring and set it within easy reach.
Feed a dowel down the barrel,stopping just before the o-ring groove.use painters masking tape to hold it at the
muzzle end.
With the safety on;pull the bolt all the way back till it locks.
Hold the rifle vertically with the muzzle down.
Obtain o-ring,and squeeze it till it looks like a figure of 8.
Stuff one half of the 8 across the breech opening,and into the groove made for it.
use your index finger tip to squash the other half of the 8 into the groove.It will open into an O shape on its own and fill the groove.
This took me 3 tries before I got it right.
Good luck,EricinMaine-