Hey Rich...

Hey Rich...

Joined: February 16th, 2007, 9:15 pm

April 3rd, 2007, 1:31 am #1

Does an RWS break barrel ie 350 or 34 basically come apart relatively the same as a Gamo? I expect there to be some differences; I am just curious if it is basically the same. Heat shrinking the guide made such an outstanding difference on the Gamos that I am considering doing the same to some of my RWS...
Last edited by diablo0470 on April 3rd, 2007, 2:28 am, edited 1 time in total.
Reply
Share

Joined: May 2nd, 2006, 4:27 am

April 3rd, 2007, 2:27 am #2

<P>The rear is set up alot different on those rifles, they have two pins that hold the trigger assembly in place and that intern holds the spring and guide in. You must have a compressor to get them apart. </P>
<P>Just lubing the spring on those will quiet down the spring noise, I would not try heat srink on them, and for certian not the 350 it woiuld rip srink apart is a few shots.</P>

http://home.comcast.net/~peterdragin/index.html/
Reply
Share

Joined: February 16th, 2007, 9:15 pm

April 3rd, 2007, 2:29 am #3

I will do a search on the forum for more info in reference to each particular gun. Thanks again.
Reply
Share

Joined: September 28th, 2006, 7:53 pm

April 3rd, 2007, 8:30 pm #4

<P>The rear is set up alot different on those rifles, they have two pins that hold the trigger assembly in place and that intern holds the spring and guide in. You must have a compressor to get them apart. </P>
<P>Just lubing the spring on those will quiet down the spring noise, I would not try heat srink on them, and for certian not the 350 it woiuld rip srink apart is a few shots.</P>

http://home.comcast.net/~peterdragin/index.html/
Rich in Mich. I took my 1250 apart except for the barrel and trigger.Now i am wondering how to get the piston out.Do i have to take the barrel off the gun? I thought it would be similar to a Diana, but it is quite different. Rich thanks for any help you can give, because i sure need it. Benson.
Reply
Share

Joined: February 14th, 2006, 4:12 pm

April 3rd, 2007, 8:45 pm #5

the shoe goes)
Reply
Share

Joined: May 2nd, 2006, 4:27 am

April 4th, 2007, 12:25 am #6

Rich in Mich. I took my 1250 apart except for the barrel and trigger.Now i am wondering how to get the piston out.Do i have to take the barrel off the gun? I thought it would be similar to a Diana, but it is quite different. Rich thanks for any help you can give, because i sure need it. Benson.
<P>The only thing that keeps the piston&nbsp; in is the cocking linkage, and if the trigger is still in the rifle it won't let it come out either it chatches the sear. Check also if there might be a screw on the scope rail sticking down into the compression tube.</P>
<P>&nbsp;</P>

http://home.comcast.net/~peterdragin/index.html/
Reply
Share