'Nother quickie projects-page update...

'Nother quickie projects-page update...

Joined: January 1st, 1970, 12:00 am

September 4th, 2017, 9:15 am #1

I finished this one up and delivered it a couple of weeks ago, and finally had thirty seconds or so to put it up in the Paintball Projects Page:

Converting an R/T Automag over to center feed.

And the money shot:


Doc.
Last edited by DocsMachine on September 4th, 2017, 9:16 am, edited 1 time in total.
Quote
Like
Share

Joined: September 11th, 2014, 1:11 pm

September 5th, 2017, 12:57 pm #2

Am i that difficult? Man do you make hard work look easy.
Quote
Like
Share

Joined: January 1st, 1970, 12:00 am

September 6th, 2017, 3:46 am #3

You're certainly the single person with the most projects in there. But that's in large part because your stuff has actually been interesting.

The usual E-Cocker rebuilds, stripped feed necks fixed, and barrels Freak-bored just aren't all that projects-page worthy.

Doc.
Quote
Like
Share

Joined: June 4th, 2017, 11:43 pm

September 7th, 2017, 4:12 pm #4

I finished this one up and delivered it a couple of weeks ago, and finally had thirty seconds or so to put it up in the Paintball Projects Page:

Converting an R/T Automag over to center feed.

And the money shot:


Doc.
"It's far too easy to gouge the body, and the stainless is far too hard to sand anything more than fairly fine markes out of. So it was a matter of careful file work..."
Quote
Like
Share