Dropped the front axle and springs out of my M16 today to make room to get the frame welded and found a few worn parts. I could use two front spring shackles and a Hanger with pin for the left side, P/N 665362. While the shackles are quite worn, they're still not too bad, but the hanger pin is worn about half way through and I would like to replace it when I put it back together. Any one out there in truck land have these parts? I would like to find new, but good used would be OK. I'm hoping that someone has these available that I could purchase. Thanks.
I did not find replacemenet shackles when I rebuilt Toto. What I did was take the old outside plates that have the shackle bolt welded to it and drilled out the bolt so that there was a hole in its place on the plate. Then replaced the old shaft with a #8 bolt. You will need to go to a place that sells bolts to get one with the needed diameter and shank length with no threads. I may have need to run the threads up on the shank some, not sure. I used nylon embedded locking bolts. I did not use the sleeves that were on the original bolts, I upsized the bolt to be the same diameter since the sleeves are not available and I didn't see the need if the bolt was the correct diamter. The rubber parts were available and probably still are. they work just fine witht the bolt.
I will be in Denver in the near future. Have an investigation to finish there. I will let you know when. I'd like to see your truck.