7 posts • Page 1 of 1
A forum for discussing bladesmithing, knifemaking, etc.
- Joined: December 2nd, 2005, 2:18 am
What kind of steel did you use for the 2 hander? Fullers would look good; I haven't tried any myself yet. My grinder is down for a run capacitor atm; I just ordered one, so hope i get it by a few days after the end of next week. Slim pickings for tech stuff here.
- Joined: July 3rd, 2018, 3:34 pm
It's OCS (old chevy spring) since it's an early 70's blazer spring, it should be 5160... I'm gonna build a spring fullering die to forge in the fullers using my little press... it should add a fuller on either side of the central ridge and make the blade wider
0 people like this