recyling pay's

.

Hosted by Luciano Rodriguez and Pat Johnston, this discussion group is dedicated to 1/48 scale AFV, vehicle and figure modelling.

recyling pay's

Joined: July 11th, 2008, 12:01 am

October 25th, 2009, 9:38 am #1

here is my redone jagdpanzer iv ,ive removed thr zimmeirt and corrected the return rollersand re done it as a 12 ss panzer division one at poteau during the battle of the bulge ,see what you think to its previous incarnation as ive been re doing older kits and fixing mistakes ive made it's been quite fun and in the end i get abetter kit for no cost plus pick up a few new skills along the way any comments good or bad go for it wayne



Quote
Like
Share

Joined: April 23rd, 2002, 1:57 pm

October 25th, 2009, 12:05 pm #2

what kits did you use there and how did you remove the zimmerite?
Quote
Like
Share

Joined: July 11th, 2008, 12:01 am

October 25th, 2009, 6:43 pm #3

OLiver's gasoline kitof the jagdpanzer,and the zimmierit was tamiya two part epoxyrolled very thin and then fitted and trimmed and patten put in .removal was easily done as thr two part putty is thin and it is not flexable so aknife edge in the corner and a little twist it pretty much falls off hope that helps wayne
Quote
Like
Share