Bernard Payne....OS2U float, struts & bomb rack hole locations.....

.

Bernard Payne....OS2U float, struts & bomb rack hole locations.....

Joined: May 20th, 2013, 10:09 am

June 18th, 2017, 5:32 pm #1

using a 6" st'stl rule, here's what I came up with. lay your wing out with a fine pointed No. 2 pencil or your favorite method. I based all the horz. measurements squared off the panel line that runs all the way across the wing root. Not the one inside of that that curls toward the panel line I'm referencing. All vert. measurements are taken from the bottom trailing edge. This is the st'bd bottom wing shown...I would assume both would be identical.
I recommend probing with a sharp pointed tool to see if measurements are true before drilling. A sharp pointed tool should poke through the thin plastic where you'll know that is indeed a
hole location. Hope this helps my friend........I added the trailing edge measurements again in case some are difficult to discern. The 3/4" and two 7/8" measurements are the distances between the holes vertically.
Last edited by peebeewhy on June 18th, 2017, 5:36 pm, edited 1 time in total.
Quote
Like
Share

Joined: March 7th, 2008, 1:53 am

June 18th, 2017, 6:48 pm #2

Many thanks Larry,That's a great help.
Quote
Like
Share

Joined: May 20th, 2013, 10:09 am

June 18th, 2017, 7:15 pm #3

Quote
Like
Share