Stator/Rectifier Which one ?

Please post all electrical, lighting and battery discussions in this topic forum.
Mike G
HSATF Member
Mike G
HSATF Member
Joined: February 24th, 2012, 8:47 pm

May 12th, 2018, 2:29 pm #31

Thanks CS , but I wouldn't want an old one .The connector had been removed from both the stator and the rectifier by the previous owner and the wires were just tied together .  I just need a new male connector to run the three wires from the mosfet to the female connector that is on the stator .do you or someone here know the name of this type of a connector ? Push on ? quick connect ? etc.etc
Quote
Like
Share

Cleve
HSATF 1st Officer
Cleve
HSATF 1st Officer
Joined: June 18th, 2009, 2:57 am

May 12th, 2018, 8:35 pm #32

they are just standard spade terminals, an auto parts store may have a replacement connector and pigtail that matches, otherwise, I'd solder and heatshrink 3 spade terminals onto the bike harness side and tape it up.

personally think a lot of the failures in the connector are caused by a poor crimp on the stator side of the oem setup, seen several toasted connectors, the worst damage at the point the wire goes int the spade term.
Cleve

Motorcycles: Bigger is NOT better, only bigger.
Quote
Like
Share

dustyblack
HSATF Tail Gunner
dustyblack
HSATF Tail Gunner
Joined: September 8th, 2010, 12:28 am

May 14th, 2018, 10:15 pm #33

Sorry, mine was on its way to being toast when I replaced the r/r. Same with my sons.
Quote
Like
Share