C6 kickdown/modulator question

Joined: December 24th, 2005, 10:39 am

April 24th, 2018, 2:58 am #1

I've been running my c6 for years without the k.d.,and just downshifting manually. At the dragstrip I just put it in drive and hold the accelerator pedal down for the best results...tho still fiddling with the modulator adjustment. Now that I've installed the locker c6 cable,I'm noticing that if I hold the gas pedal to the floor it won't shift up unless I lift a little and then when I tip back into it- it will downshift again. I've adjusted it per the locker instructions,I'm having second thoughts about leaving the cable hooked up. I know that I read somewhere in this forum about the correlation of the k.d. and the modulator and the governor. I hate to start messing with the modulator adjustment since I've almost got it dialed in. What am I doing wrong with the cable? Any input or constructive criticism is welcomed! Thanks, Steve
Quote
Like
Share

Joined: December 24th, 2005, 10:39 am

April 24th, 2018, 3:07 am #2

My post was to say Lokar not Locker! Damn auto-correct on my phone!
Quote
Like
Share

Joined: November 18th, 2004, 4:20 am

April 24th, 2018, 3:14 am #3

Remove the lokar cable. You probably have it strung too tight.

KD cable or linkage is not needed on C6 or C4.

Can you say wire cutters? 😜
Last edited by stuart40a on April 27th, 2018, 10:04 pm, edited 1 time in total.
Quote
Like
Share

Joined: December 24th, 2005, 10:39 am

April 24th, 2018, 8:11 am #4

Ok,as I thought....Thank you for verification on that!
Quote
Like
Share