I am trying to figure out if I can swap a 24 series C6 with a 1989 series 25 bell. The C6 that I am trying to use cam out of a car, and is thus shorter in length. Can I just swap the tail ends of the tranny?
If the truck is a 4x2, the extension housing should be the same length unless the car C6 is a Lincoln. Most likely the shift linkage will be different between the two. If the truck is a 4x4, the tranny has to be completely disassembled to remove the output shaft. The same goes for the car C6 if the output has to be swapped.
Ken Collins, BadShoe Productions, How To DVD's specializing in Ford drivetrains www.badshoeproductions.com (banner ad below)