sorry to reopen topic, I was thinking an aluminum main tube would be best for cane gun

sorry to reopen topic, I was thinking an aluminum main tube would be best for cane gun

Joined: April 28th, 2010, 12:23 am

December 22nd, 2011, 8:11 pm #1

easy to work with , hide the barrel and small air charge, with foster nipple hidden in the rubber butt that rests on the ground.... maybe use a 2240 action converted to hpa(simple) , reconfigure the trigger for a lower profile .
But then how do u make this aluminum tube look like a classic wooden cane??share ideas/.
Last edited by robnewyork on December 22nd, 2011, 8:14 pm, edited 1 time in total.
Reply
Like
Share

Joined: March 1st, 2002, 12:22 am

December 22nd, 2011, 9:16 pm #2


in wood grain.

Lots of the older folk have aluminum canes, black laquer, dips.....  red spray paint.

White with a red tip, just wear yer sun glasses


dr_subsonic's pneumatic research lab

the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic
Reply
Like
Share

Joined: April 28th, 2010, 12:23 am

December 22nd, 2011, 9:39 pm #3

as cia as possible lol.... i was holding tube next to 1377, the conventional breech needs to be abandoned, and the air space inside the tube could be ample... small hole in the cane for loading, trigger mech near the curve of the cain because otherwise the trigger profile is wayyyyy to wide for a 1 inch i.d pipe.... but the gun could have a 24 inch barrel no issue, biggest issue is the trigger pack being a bit tall...basically a metal slide at the back of the barrel is all thats needed to void and nullify the need for a breech.
the little cocking hammer pin could stick out the side of the tube, at 6 feet away no one would notice the tiny lil pin.
Last edited by robnewyork on December 22nd, 2011, 9:42 pm, edited 1 time in total.
Reply
Like
Share

Joined: October 15th, 2008, 2:18 am

December 22nd, 2011, 10:12 pm #4

easy to work with , hide the barrel and small air charge, with foster nipple hidden in the rubber butt that rests on the ground.... maybe use a 2240 action converted to hpa(simple) , reconfigure the trigger for a lower profile .
But then how do u make this aluminum tube look like a classic wooden cane??share ideas/.
make it like a candy cane. It is christmas
Reply
Like
Share

Joined: April 28th, 2010, 12:23 am

December 22nd, 2011, 10:15 pm #5

hahah, id look like a jackasss walkin with it mid summer! nt
Reply
Like
Share

Joined: March 1st, 2002, 12:22 am

December 22nd, 2011, 11:57 pm #6

nt

dr_subsonic's pneumatic research lab

the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic
Reply
Like
Share

Joined: April 28th, 2010, 12:23 am

December 23rd, 2011, 12:08 am #7

then drop right into the tube/
Reply
Like
Share