Barrel O.D. for Older Sheridans

Barrel O.D. for Older Sheridans

Joined: December 10th, 2007, 3:34 pm

August 7th, 2012, 12:50 am #1



I'd like to get an Intermount (with Slotted screws )vs. hex cap screws for a friends older Sheridan 5 MM ,but I may need a spacer between Actual barrel Dia. & I.D. of Intermount,since they're made for .435 O.D. Barrels likr the 13XX & 22XX's any suggestions/ideas?

Mario

Lock - N - Load!
Reply
Like
Share

Joined: February 9th, 2006, 10:35 pm

August 7th, 2012, 9:23 am #2

Here's what you need, they work great on my '65 Sheridan as well as my late model Benjamin.

http://centerpoint.crosman.com/accessories/B272
http://www.pyramydair.com/s/a/Crosman_B ... vetail/191


You might also check out the INTEGRABASE.

I plink, therefore I am.
Reply
Like
Share

Joined: December 14th, 2010, 5:08 am

August 8th, 2012, 1:09 am #3


I'd like to get an Intermount (with Slotted screws )vs. hex cap screws for a friends older Sheridan 5 MM ,but I may need a spacer between Actual barrel Dia. & I.D. of Intermount,since they're made for .435 O.D. Barrels likr the 13XX & 22XX's any suggestions/ideas?

Mario

Lock - N - Load!
but the outer diameter on my 397 and 392 is 11/32"
Reply
Like
Share

Joined: December 10th, 2007, 3:34 pm

August 10th, 2012, 2:18 pm #4

Here's what you need, they work great on my '65 Sheridan as well as my late model Benjamin.

http://centerpoint.crosman.com/accessories/B272
http://www.pyramydair.com/s/a/Crosman_B ... vetail/191


You might also check out the INTEGRABASE.

I plink, therefore I am.
Hi

My friends Sheridan is of the rocker safety models. I guess I'll have to Get My Calipers & go Measure that Barrel..and I can use the B272 4pc. set up & make a tube the same O.D. as the I'D.
of the part that would fit on the barrel. I believe,if I'm not mistaken that B272 Mounts to a 7/16"
(or .435)barrel like those of the 13XX,22Xx series guns. after I make tube(7/16" O.D.) with whatever size hole will slide easily over 'dan barrel I can drill 2 holes,tap for 8-32 and put set screws to hold Base tube to barrel then affix B272 to it and Voila!

Mario

Lock - N - Load!
Reply
Like
Share