Information: This forum has been set to read only for archive purposes. The link to active FE forum is https://www.fordfe.com/index.php

side oiler with tunnel port dual plane intake - comments?

side oiler with tunnel port dual plane intake - comments?

Joined: May 17th, 2002, 4:32 am

August 3rd, 2004, 10:05 am #1

Found a 'fresh' side oiler for a new project. Have not seen (or heard) the motor yet but have limited info (no part/casting #'s as yet). Any comments would be appreciated.

a) side oiler block .015 over (no sleeves)
b) steel stroker crank 454 (aftermarket - not 428)
c) 'H' beam rods
d) Weisco forged pistons 10:1
e) tunnel port heads
f) orig dual plane tunnel port intake w/2 Holleys
g) Comp Cams solid lifter cam (grind not known at this time)
h) Aviad oil pan
i) no clutch/pp or bellhousing

The motor was recently built by a reputable engine builder and has 0 street miles according to seller. I can get documentation from the engine builder and hear it run at his shop. Seller wants 20k.

Thanks,

Melzer
Reply
Like
Share